NORDTEK DANMARK - Toroid Transformers 230V, 2xSec, 15-1000VA, General Information - nordtek.dk

Tell a friend Enquiry print

Toroid Transformers 230V, 2xSec, 15-1000VA, General Information


High quality open style toroidal transformers with a single 230V a.c., 50/60Hz primary winding.
Twin secondary windings may be connected in series, parallel or used independently.

  • Small size and low weight compared with traditional stacked lamination types
  • Extremely low level of radiated magnetic field
  • Very low induced noise (hum)
  • Very low iron loss
  • Supplied with mounting kit 
  • 100% electrical and flash tested
  • High quality manufacturing and testing in accordance to:
    EN61558, EN60742, EN60950, EN60065, VDE0551, VDE0550 and BS415
  • Tested and Approved by KEMA to EN61558 
  • UL Recognised to UL506 
   Toroid Transformers 230V, 2xSec, 15-1000VA




Rated VA Part Number
(xxx=Sec voltage)		 Regulation
% Typical		 Temperature Rise [K] Dimensions*
Diameter [mm]		 Height [mm] Weight [Kg]
15 0015P1-2-xxx 16 26 60 31 0.30
30 0030P1-2-xxx 18 40 70 32 0.45
50 0050P1-2-xxx 14 42 80 33 0.65
80 0080P1-2-xxx 14 53 93 38 0.90
120 0120P1-2-xxx 10 52 93 46 1.20
160 0160P1-2-xxx 9 55 105 42 1.50
225 0225P1-2-xxx 8 60 112 47 1.90
300 0300P1-2-xxx 8 60 115 58 2.30
500 0500P1-2-xxx 6 68 136 60 3.50
625 0625P1-2-xxx 5 67 136 68 4.30
800 0800P1-2-xxx 5 69 162 60 5.10
1000 1000P1-2-xxx 5 72 162 70 6.50


  • * Allow extra 4mm for mounting kit, allow extra 5mm where leads emerge
  • Leads: PVC insulated 150mm long
  • Secondary voltage tolerance <1% at nominal input
  • UL recognised for Insulation Class A (105°C)
  • Maximum ambient operating temperature +40°C
  • Neoprene pads: 5kV isolation
  • Meets all requirements of Class E (120°C)


Important Installation Note

Each transformer is supplied with a dished washer and protection pads for single hole fixing. Ensure that the pads are fitted above and below the transformer winding and that the dished washer is on top of the upper pad. Do not over tighten the fixing bolt (not supplied) as this could damage the winding.
Under no circumstances should both ends of the fixing bolt contact a metal chassis or frame as this would create a "shorted turn" causing irreparable damage.

Top of page